/03-dataspace-dashboard/01-initial-setup.html The following sections provide guidance on initialising your dataspace dashboard using the first-time setup wizard. The setup procedure differs depending on whether you have launched a full testbed or a standalone component. Select the appropriate guide from the table below: Name Purpose 3.1.1 Configure for a Testbed Learn how to link your dashboard to a full testbed deployment 3.1.2 Configure for a Connector Learn how to link your dashboard to a standalone IDSA connector Hugo en-us /03-dataspace-dashboard/01-initial-setup/setup-testbed.html Mon, 01 Jan 0001 00:00:00 +0000 /03-dataspace-dashboard/01-initial-setup/setup-testbed.html This page explains how to configure the dashboard for use with a complete testbed deployment. You should perform these steps once for each new provisioned testbed before use. Launch the Testbed Dashboard Once your dataspace is launched, click the Dashboard button to open the built-in dashboard. If you see a connection warning, select proceed. You will be presented with the dashboard landing page and a setup wizard to guide you through the key configuration steps. /03-dataspace-dashboard/01-initial-setup/setup-connector.html Mon, 01 Jan 0001 00:00:00 +0000 /03-dataspace-dashboard/01-initial-setup/setup-connector.html This page explains how to configure the dashboard for use with a standalone connector deployment. Generate a Trusted Identity for your Connector Before you can use your connector, you must generate a certificate bundle for your connector from the testbed you are connecting it to. Follow the steps below to generate an SSL certificate bundle. Navigate to the Settings page of your testbed dashboard (not your connector) from the left navigation: